Posology : מינונים

DOSAGE AND ADMINISTRATION
The recommended dosage per test is 0.1 mL of TUBERSOL, comprising 5 tuberculin units (TU) .
The Mantoux test is performed by injecting 0.1 mL (5 Tuberculin units per test dose) of TUBERSOL intradermally in the volar aspect of the forearm
TUBERSOL is a clear colourless liquid. Inspect for extraneous particulate matter and/or discolouration before use. If these conditions exist, the product should not be administered.
Method of Administration
TUBERSOL is indicated for intradermal injection only. Do not inject intravenously, intramuscularly, or subcutaneously. If subcutaneous injection occurs, the test cannot be interpreted.
Inspect for extraneous particulate matter and/or discoloration before use. If these conditions exist, do not administer the product.
Use a separate syringe and needle for each injection.

The following procedure is recommended for performing the Mantoux test: 1. The preferred site of the test is the volar aspect of the forearm. Avoid areas on the skin that are red or swollen. Avoid visible veins.
2. Clean the skin site with a suitable germicide and allow the site to dry prior to injection of the antigen.
3. Administer the test dose (0.1 mL) of TUBERSOL with a 1 mL syringe calibrated in tenths and fitted with a short, one-quarter to one-half inch, 26 or 27 gauge needle.
4. Wipe the stopper of the vial with a suitable germicide and allow to dry before needle insertion. Then insert the needle gently through the stopper and draw 0.1 mL of TUBERSOL into the syringe. Avoid injection of excess air with removal of each dose so as not to over pressurize the vial and possibly cause seepage at the puncture site.
5. Insert the point of the needle into the most superficial layers of the skin with the needle bevel pointing upward and administer the dose by slow intradermal injection. If the intradermal injection is performed properly, a definite pale bleb will rise at the needle point, about 10 mm (3/8") in diameter. This bleb will disperse within minutes. Do not dress the site.

6. A drop of blood may appear at the administration site following injection. Blot the site lightly to remove the blood but avoid squeezing out the injected tuberculin test fluid.
In the event of an improperly performed injection (i.e., no bleb formed), repeat the test immediately at another site, at least 5 cm (2 inches) from the first site and circle the second injection site as an indication that this is the site to be read.
Inform the patient of the need to return for the reading of the test by a trained health professional.
Self-reading may be inaccurate and is strongly discouraged.
Interpretation of the Test
The skin test should be read by a trained health professional 48 to 72 hours after administration of TUBERSOL. Skin test sensitivity is indicated by induration only; redness should not be measured.
Measure the diameter of induration transversely to the long axis of the forearm and record the measurement in millimeters (including 0 mm). The tip of a ballpoint pen, gently pushed at a 45° angle toward the site of injection, will stop at the edge of induration.
Also record presence and size (if present) of necrosis and edema, although these are not used in the interpretation of the test.
Positive Reactions
Tuberculin reactivity may indicate latent infection, prior infection and/or disease with M.
tuberculosis and does not necessarily indicate the presence of active tuberculous disease. Persons showing positive tuberculin reactions should be considered positive by current public health 

guidelines and referred for further medical evaluation. The repeated testing of uninfected persons does not sensitize them to TUBERSOL.
The significance of induration measurements in diagnosing latent TB infection must be considered in terms of the patient’s history and the risk of developing active TB disease as indicated in Table 1.
Table 1: Criteria for tuberculin positivity, by risk group

Reaction ≥5 mm of Induration              Reaction ≥10 mm of Induration                                     Reaction ≥15 mm of
Induration

HIV-positive persons                      Recent immigrants (i.e., within the last 5 yrs) from              Persons with no high prevalence countries                                         risk factors for Recent contacts of tuberculosis                                                                             TB (TB) case patients                        Injection drug users

Fibrotic changes on chest                 Residents or employees† of the following high-risk radiograph consistent with prior          congregate settings: prisons and jails, nursing homes TB                                        and other long-term facilities for the elderly, hospitals and other healthcare facilities, residential facilities for
Patients with organ transplants and patients with acquired immunodeficiency syndrome other immunosuppressed patients
(AIDS) and homeless shelters
(receiving the equivalent of ≥15 mg/d of prednisone for 1 month or         Mycobacteriology laboratory personnel more)*
Persons with the following clinical conditions that place them at high risk: silicosis, diabetes mellitus,
chronic renal failure, some hematologic disorders (e.g.,
leukemias     and      lymphomas),    other    specific malignancies (e.g., carcinoma of the head or neck and lung), weight loss of ≥10% of ideal body weight,
gastrectomy and jejunoileal bypass
Children younger than 4 yrs of age or infants, children,
and adolescents exposed to adults at high-risk


* Risk of TB in patients treated with corticosteroids increases with higher dose and longer duration.
† For persons who are otherwise at low risk and are tested at the start of employment, a reaction of ≥15 mm induration is considered positive.

A TST conversion is defined as an increase of ≥10 mm of induration within a 2-year period, regardless of age.
The possibility should be considered that the skin test sensitivity may also be due to a previous contact with atypical mycobacteria or previous BCG vaccination.
Negative Reactions


An individual who does not show a positive reaction to 5 TU on the first test, but is suspected of being TB positive, may be retested with 5 TU. (See Booster Effect and Two-Step Testing.) Any individual who does not show a positive reaction to an initial injection of 5 TU, or a second test with 5 TU may be considered as tuberculin negative.
False Positive Reactions
False positive tuberculin reactions can occur in individuals who have been infected with other mycobacteria, including vaccination with BCG. However, a diagnosis of M. tuberculosis infection and the use of preventive therapy should be considered for any BCG-vaccinated person who has a positive TST reaction, especially if the person has been, or is, at increased risk of acquiring TB infection.
False Negative Reactions
Not all infected persons will have a delayed hypersensitivity reaction to a tuberculin test.
In those who are elderly or those who are being tested for the first time, reactions may develop slowly and may not peak until after 72 hours.
Since tuberculin sensitivity may take up to 8 weeks to develop following exposure to M.
tuberculosis (see Mechanism of Action), persons who have a negative tuberculin test <8 weeks following possible TB exposure should be retested ≥8-10 weeks following the last known or suspected exposure.
Altered Immune Status
Impaired or attenuated cell mediated immunity (CMI) can potentially cause a false negative tuberculin reaction. Many factors have been reported to cause a decreased ability to respond to the tuberculin test in the presence of tuberculous infection including viral infections (e.g., measles, mumps, chickenpox and HIV), live virus vaccinations (e.g., measles, mumps, rubella, oral polio and yellow fever), overwhelming tuberculosis, other bacterial infections, leukemia, sarcoidosis, fungal infections, metabolic derangements, low protein states, diseases affecting lymphoid organs, drugs (corticosteroids and many other immunosuppressive agents), and malignancy or stress. A TST should be deferred for patients with major viral infections or live-virus vaccination in the past month. Persons with the common cold may be tuberculin tested.
Because TST results in HIV-infected individuals are less reliable as CD4 counts decline, screening should be completed as early as possible after HIV-infection occurs.
Booster Effect and Two-Step Testing
If tuberculin testing will be conducted at regular intervals, for instance among healthcare workers or prison workers, two-step testing should be performed as a baseline to avoid interpreting a booster effect as a tuberculin conversion. If the first test showed either no reaction or a small reaction, the second test should be performed one to four weeks later. Both tests should be read and recorded at 48 to 72 hours.
Patients with a second tuberculin test (booster) response of ≥10 mm should be considered to have experienced past TB infection.

Persons who do not boost when given repeat tests at one week, but whose tuberculin reactions change to positive after one year, should be considered to have newly acquired tuberculosis infection and managed accordingly.